What does Integrator do?
– Rogowski coil output is weak voltage mV signal,S2 has ability to amplify and convert it to standard signal which could be catched by multimeter and scope.
– Rogowski coil output is proportional to the frequency of the measured current, the signal equalization ensure a linear response on a wide frequency range. S2 allows to use coils on different electrical network frequencies, keeping the same output level over the frequencies.
– An integrator is essential to equalize and shift by 90° the output signal from the Rogowski coils. It consists of an active electronic circuit with negligible offset and a good linearity.
S2 can be combined with any model and size of NRC,MRC,Y-FCT Rogowski coils.
The available values are: 3Vac.
On request the input value can be customized according to the application.
S2 and Rogowski coil is a very flexible system, suitable for high power load analysis, impulsive current monitoring, DC ripple measurement, etc.
Due to its specific features, flexible Rogowski coil is an extremely comfortable solution for current measurement and can be used in a number of cases where traditional current transducer is not the adequate solution.